SAL
Cooling electrical pump for MIG-Plasma
 |
UTILIZATION
These peripheral electrical pumps are made to reach a hight pressure,
even with a relatively small motor. Thanks to their reduced dimensions,
they're particularly suitable to be set on apparatus and machines to
increase pressure and cooling of temperatures. Easy to be examined,
there's the possibility to repair the pump and the motor separately. the
pumping part can be turned 90°C in 90° C. In the self-priming type SAL
35 this operation is not possible. These pumps are made to handle clean
water only, chemically non abrasive liquids and without solids. Suitable
to operate at a continuous service (ES 100%).
Maximum numbers of interventions 5/min. or 40/h.
Operating temperature -20°C+60°C.
MATERIALS
- Impeller, pump body and wear plate in brass
- Stainless steal shaft INOX AISI 420 (x30 Cr 12)
- Mechanical seal in graphite-ceramic-EPDM (VITON on request)
- Ball bearings of first quality
- Hose connector in brass on request
- Sucking or blowing aluminium fan Ø 150-170-200mm on request
EXECUTION
- with fan MEC 56
- Without connection box and with separated
capacitor
- With connection box and mounted capacitor
- Built-in overload motor protection that can be
disconnected
Pumping part isolated from the other details.
The isolation has been realized using special plastic materials on the
motor and on the shaft.
ISOLATION BETWEEN PUMP AND MOTOR 4 KV.
ISOLATION BETWEEN MOTOR AND SHAFT 4 KV.
MOTOR
- 2 Pole induction motor
– Single-phase: 110v 50Hz/230V 50/60Hz with the same pump / 400V/50Hz
– Three-phase:230/400v 50Hz with connection box
- Other tensions and frequencies on request.
- Isolation class F
- Protection IP 44
TOLERANCES AND TESTS
- for the pump, corresponding to ISO 2548
- For the motors, corresponding to C.E.I. norm.
- Electrical and hydraulic test at 100% |
